SD-P2AF Pressure Gauge are specifically designed for Fire Sprinkler Services. The pressure gauge is UL Listed and FM approved. It has corrosion resistant polished stainless steel case and Bezel and Brass wetted parts. The dial has pressure reading in KG/SQCM and PSI. The gauge window is hardened glass.

The post PRESSURE GAUGES appeared first on NAFFCO Australia.

The post SWING CHECK VALVE – 363 Psi appeared first on NAFFCO Australia.

The post Non Rising Stem Gate Valve – 360 Psi – Sea Water Application appeared first on NAFFCO Australia.

The post OS & Y Gate Valve – 360 Psi- Sea Water Application appeared first on NAFFCO Australia.

The post PRESSURE REDUCING VALVE appeared first on NAFFCO Australia.

The post PRESSURE RELIEF VALVE appeared first on NAFFCO Australia.

The post PRESSURE RELIEF VALVE SD-RV20CA appeared first on NAFFCO Australia.

The post Residential Control Valve Assembly appeared first on NAFFCO Australia.

The post Residential Control Valve Assembly with Cabinet appeared first on NAFFCO Australia.

Retarding Chamber is used with Alarm Valve Trim when variable pressure is anticipated in the system. It is a holding tank to prevent activation of the Sprinkler Alarm during water pressure surge, but permits the activation of alarm on sustained flow. The Retarding Chamber is part of UL Listed and FM Approved Alarm Valve Trim. The Retarding Chamber is made of stainless steel material and rated for 17.5 bar pressure.

The post Retard Chamber appeared first on NAFFCO Australia.

SHIELD Sprinkler Alarm is a hydraulically driven mechanical bell. It does sound a continuous alarm when the sprinkler system operates. The impeller and drive shaft are energy efficient, made from light weight nonmetallic material and do not require any external lubrication. The gong, protection cover and motor housing are made of corrosion resistant aluminium alloy.

Sprinkler Alarm with mounting Type-B is wall mounting type. Type-B is suitable for 50 to 250 mm thick wall and curves with 325 mm long drive shaft as standard supply. For wall thickness 250 to 450 mm or longer a special extension drive shaft can be supplied on request.

The post Sprinkler Alarm appeared first on NAFFCO Australia.

The SD-PS Series Pressure Switches shall be installed on the sprinkler system with connection as shown on the drawings and/or as specified herein. Pressure switches shall be of the bellows-activated type. Switches shall have a maximum service pressure rating of 300 psi and shall be factory adjusted to operate at a pressure of 4 – 8 psi. There shall be one (1) or two (2) SPDT contacts rated at 10.0 Amp @ 125/250 VAC and 2.5 Amp @ 30 VDC. The contractor shall furnish and install, where indicated on the plans, pressure switches according to appropriate NFPA standards. Switches shall be provided with a ½˝ NPT male pressure connection to be connected to the alarm check valve of a “wet” sprinkler system, into the intermediate chamber of a “dry” system, or to a pre-action or deluge valve. They shall be activated by any flow of water equal to or in excess of the discharge from one sprinkler head. Switches shall provide 1 knockout type and 1 open hole for ½˝ conduit fitting attachment and a ground screw provision for electrical grounding. The switch enclosure shall be weatherproof. The cover shall incorporate tamper-resistant screws. The unit shall be listed by Underwriters Laboratories, Inc. and approved by Factory Mutual.

The post PRESSURE SWITCH appeared first on NAFFCO Australia.